sp1187
Junior Member
Posts: 33
|
Post by sp1187 on Apr 9, 2018 22:59:37 GMT -5
Greetings. So I received my rail system. 1090mm Rails (2) Cross Link Bar Set #1883 (1) MMS Endcaps #1879 (2) Suspension Kit #1823 (2) Issue 1: Hex Nuts, not Square Nuts included. Issue 2: Cross Link Bar was redesigned and the contact surface for the end cap isn't wide enough. The end caps don't mount flash to the bar. Or did they redesign the end caps and I have old ones for the old design? solutions? Mike
|
|
|
Post by saw on Apr 10, 2018 13:09:04 GMT -5
Hi Mike,
As long as the hex nuts are flat on top and bottom the nut should go in the same.
The length of the new cross link bar is the same as the old one. I agree the end caps don't fit as flush on the bar. As far as I know the end caps have not been redesigned.
I am not as big of a fan of the new cross link bars, but it looks like they are trying to make it look more sleek.
|
|